Skewing and stretching objects

You can skew and stretch objects in CorelDRAW. When you skew an object, you specify the degree by which you want to slant the object. Stretching changes an object’s vertical and horizontal dimensions non proportionally.

CorelDRAW also lets you change the skew and sizing anchor point of an object from its default center position.

Skewing an object horizontally

Stretching an object horizontally

To skew an object

•

In the toolbox, click the Free transform tool .

•

Click Window Toolbars Transform.

3 .	Click the Free skew button on the property bar.

If you want to apply the scaling according to the object’s position rather than the x and y coordinates, click the Relative to object button on the property bar.

You can also skew an object interactively by dragging one of its skew handles . If the skew handles are not displayed, click the selected object again, and point to the middle handles.

You can also access skewing options from the Transformation docker by clicking Object Transformations Skew.

To stretch an object

2 .	Click Object Transformations Size.

The new values that you enter to stretch an object are the basis for a new ratio of the horizontal and vertical dimensions of the object. When you enable the Proportional check box, any resizing of the object is based on this new ratio. To revert the object to its original one-to-one proportions before transforming it again, you must enable the Proportional check box, and then retype the original values.

You can change object dimensions proportionally by enabling the Proportional check box, typing a value in either the H or V box, and pressing Enter.

You can also stretch an object from its center by pressing Shift and dragging a corner selection handle.

You can also stretch an object in increments of 100% by pressing Ctrl, and dragging a corner selection handle.

---

Was this page helpful? Send feedback. (Internet connection required.)

---

Copyright 2018 Corel Corporation. All rights reserved.