Quick links to procedures on this page:

Positioning objects

You can position objects by dragging them to a new location, by nudging, or by specifying their horizontal and vertical coordinates.

Nudging lets you move an object in increments by pressing the Arrow keys. The increment value is known as "nudge distance." Micro-nudging lets you move an object by a fraction of the nudge distance. Super-nudging lets you move an object by a multiple of the nudge distance. By default, you can nudge objects in 0.1‑inch increments, but you can change this increment value to suit your needs. You can also change micro-nudge and super-nudge values.

To position an object, you can set horizontal and vertical coordinates that are relative to the center anchor point, or other anchor point, of the object.

You can also move an object to another page. For more information, see To move an object to another page.

To move an object Back to Top

*

You can move an object to another page by dragging the object over a page number tab at the bottom of the document window and then dragging the object into the document window.

To move an object while drawing Back to Top

Moving an object while drawing

To nudge an object Back to Top

 

Press an Arrow key.
Hold down Ctrl, and press an Arrow key.
Hold down Shift, and press an Arrow key.
To set nudge distances Back to Top

*

You can also set the nudge distance by deselecting all objects and typing a value in the Nudge distance box on the property bar.

To save the new nudge distances to use in new drawings, click Tools Save settings as default.

To position an object by x and y coordinates Back to Top

*

The object origin, also known as "anchor point" or "reference point," can be the center of an object or any one of the object’s selection handles. The object origin remains stationary when an object is positioned by typing values in the x and y boxes on the property bar.

To position an object by changing the anchor point Back to Top

*

By default, the point of origin (0,0) is at the lower-left corner of the drawing page.

When you enable the Relative position check box on the Transformation docker, the position of the center anchor point is identified as 0,0 in the H and V boxes. When you specify a different position in the H and V boxes, the values represent a change from the current position as measured from the center anchor point of the object.


Feedback
Was this page helpful? Send feedback. (Internet connection required.)

Copyright 2015 Corel Corporation. All rights reserved.